{"product_id":"brodit-actieve-houder-panasonic-fz-l1-713101","title":"Brodit Actieve Houder 713101 - Tablethouder Panasonic FZ-L1","description":"\u003cp\u003eBrodit Actieve Houder 713101.\u003c\/p\u003e\n\u003cp\u003eMet de Brodit Actieve Houder 713101 plaatst u uw Panasonic FZ-L1 stevig in de auto en laadt u het toestel automatisch op tijdens het rijden met Molex-laden. Geen losse oplaadkabel die u steeds opnieuw moet aansluiten: u schuift uw toestel in de houder en de verbinding wordt direct gemaakt.\u003c\/p\u003e\n\u003cp\u003e\u003cstrong\u003eLet op:\u003c\/strong\u003e deze tablethouder heeft een montagebasis nodig om in de auto te bevestigen. U bestelt dus altijd twee artikelen: deze houder en een Brodit ProClip (of vergelijkbare montageplek) die op het dashboard van uw specifieke auto past. Deze houder is op maat gemaakt voor het toestel en past niet met een hoesje of skin om het apparaat.\u003c\/p\u003e\n\u003cp\u003eDe actieve houder werkt automatisch zodra u uw toestel in de houder plaatst — laden en gebruik tegelijk, zonder dat u zelf kabels hoeft aan te sluiten. Dankzij de tilt swivel kantelt u de houder voor de juiste kijkhoek.\u003c\/p\u003e\n\u003cul\u003e\n  \u003cli\u003eOp maat gemaakt voor Panasonic FZ-L1\u003c\/li\u003e\n  \u003cli\u003eAutomatisch laden bij plaatsing in de houder\u003c\/li\u003e\n  \u003cli\u003eTilt swivel voor de ideale kijkhoek\u003c\/li\u003e\n  \u003cli\u003eVolledige toegang tot knoppen en aansluitingen\u003c\/li\u003e\n  \u003cli\u003eBrodit-kwaliteit uit Zweden\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003eCombineer de Brodit Actieve Houder 713101 met een voertuigspecifieke Brodit ProClip en u heeft een complete, veilige en handige oplossing om uw toestel in de auto te gebruiken en op te laden.\u003c\/p\u003e\n\u003cp\u003e\u003cstrong\u003eProductspecificaties:\u003c\/strong\u003e\u003c\/p\u003e\n\u003cul\u003e\n  \u003cli\u003eHoogte: 155 mm\u003c\/li\u003e\n  \u003cli\u003eBreedte: 213 mm\u003c\/li\u003e\n  \u003cli\u003eDiepte: 50 mm\u003c\/li\u003e\n  \u003cli\u003eVolume: 1651 cm³\u003c\/li\u003e\n  \u003cli\u003eGewicht: 442 g\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003e\u003cstrong\u003eGeschikt voor:\u003c\/strong\u003e\u003c\/p\u003e\n\u003cul\u003e\n  \u003cli\u003ePanasonic FZ-L1\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003e\u003cstrong\u003eProductinformatie van fabrikant (Engels):\u003c\/strong\u003e\u003c\/p\u003e\u003cp\u003e\u003cem\u003eUse an active holder for your Panasonic while driving and you will always have a freshly charged battery! The active holder is to be connected inside the dashboard. It provides a discreet and neat installation without any cables hanging over the interior. Safe and convenient! 12\/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Charging via pogo plug. Professional installation recommended.\u003cbr\u003e \u003cbr\u003eEasy-switching system: \u003cbr\u003eThe easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.\u003cbr\u003e\u003cbr\u003eThe holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position. It is easy to put the unit into place in the holder, and to take it with you when leaving the car.\u003cbr\u003e \u003cbr\u003eTablets (Surfpads) should not be installed onto a car’s dashboard if they block the view or block key controls. ProClip (Brodit’s vehicle mounting bracket) is designed for installation of smaller devices like mobile phones and GPS devices, ProClip is not designed for large devices like tablets. In some vehicles the ProClip has an extra firm fit and can then be used also for installation of a tablet. If you want to place a tablet onto the car’s dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations. \u003cbr\u003e \u003cbr\u003eAn installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit recommends to use tablets on the car’s headrest, installed onto a Brodit headrest mount.\u003c\/em\u003e\u003c\/p\u003e","brand":"Brodit","offers":[{"title":"Default Title","offer_id":57848979489032,"sku":"713101","price":114.95,"currency_code":"EUR","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/1042\/2291\/6872\/files\/713101_8d713c8f-f22d-48ba-bcaa-91fd06348e4d.jpg?v=1780496726","url":"https:\/\/carkitstunter.nl\/products\/brodit-actieve-houder-panasonic-fz-l1-713101","provider":"CarkitStunter.nl","version":"1.0","type":"link"}