Brodit Houder met Slot 735333 - Tablethouder Zebra ET45 10 / ET40 10

Brodit Houder met Slot 735333.

De Brodit Houder met Slot 735333 houdt uw Zebra ET45 10 of ET40 10 veilig op zijn plek in de auto, met een sleutel-vergrendeling die ongeautoriseerde verwijdering voorkomt. Ideaal voor zakelijk gebruik of dure apparatuur.

Let op: deze tablethouder heeft een montagebasis nodig om in de auto te bevestigen. U bestelt dus altijd twee artikelen: deze houder en een Brodit ProClip (of vergelijkbare montageplek) die op het dashboard van uw specifieke auto past.

De houder is voorzien van een sleutel-vergrendeling. Sleutels worden meegeleverd. Speciaal ontwikkeld voor professionele toepassingen waar veiligheid van uw apparatuur essentieel is.

• Sleutel-vergrendeling tegen diefstal
• Sleutels meegeleverd
• Op maat gemaakt voor het toestel
• Geschikt voor professioneel/zakelijk gebruik
• Brodit-kwaliteit uit Zweden

Geschikt voor:

• Zebra ET45 10
• Zebra ET40 10

Productinformatie van fabrikant (Engels):

The Zebra ET4x series Module Upgrade Cradles from Brodit are designed to withstand frequent wear and tear in professional every day use, providing a more productive working day and better working environment with your device within sight and reach. Safe, efficient and convenient!
 
The cradle is customized with a perfect fit for devices with or without any expansion back module/handstrap, Otterbox Utility series Latch handstrap. It has a robust design for use in a normal forklift environment. You have full access to the camera,scanner, buttons and ports while docked. Easy one-hand insertion and removal.
 
This holder is the perfect choice when you want both charging and USB-Host function for your device. The USB-A port provides up to 1.5A, so even the most demanding barcode scanner, keyboard, sensor or other accessory can be connected directly to the device.
 
The USB-A port can be powered in two ways: When the holder is connected to an EXTERNAL power source via 12Vdc, the USB-A port outputs 1.5A 5Vdc. When the holder is used WITHOUT an external 12Vdc power source, the USB-A port gives 0.9A 5Vdc. Then equipment connected to the USB-A port is supplied with power from the ET4x.
 
Easy-switching system:
The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.
 
This is a Module Upgrade Cradle, this means that you can upgrade or replace features by using some of the following modules:
Item no. 216341 Spring stud lock
 
Choose installation placement with care, devices must not be placed in positions where they may block the view or important controls. The cradle should only be attached onto a suitable place. Installations always take place at the customer's own discretion and responsibility.