Brodit houder lader 736149 Samsung Galaxy Tab Act.Pro Fixed install.LOCK USB Host

Brodit
7320287361490
Bestel
  • Beschrijving

Brodit houder lader 736149 Samsung Galaxy Tab Act.Pro Fixed install.LOCK USB Host

Holder with lock.

 

Active holder for fixed installation, with tilt swivel. Fits for devices with original skin. 2 keys included. With USB Host.

 

This holder is to be used when you want to secure your Tab Active Pro and still have it easy accessable.

The active holder is to be connected inside the dashboard. It provides a discreet and neat installation without any cables hanging over the interior. Safe and convenient! 12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 1 A charger. Charging via pogo plug. Professional installation recommended.

Easy-switching system:

The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.

The holder is also perfect for use in stores, at exhibitions and any place where you want to use your Tab Active Pro without having it easy removable. The holder is equipped with a lock. In order to remove the Tab Active Pro from the holder you need the key, two keys are included.  The holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position.

Tablets should not be installed onto a car's dashboard if blocking the view or key controls. ProClip is designed for use with smaller devices like smartphones. If you want to place a tablet onto a dashboard, each combination of tablet-car must be examined in detail by yourself in order to determine if such an installation is possible in the specific case. Brodit will not give any recommendations for such installations. An installation of a tablet onto a vehicle's dashboard is always done on the customer's own responsibility. Brodit recommends using tablets on the car's headrest, installed onto a Brodit headrest mount.